IMA Schelling Group brings refurbished Edgebanders and Panel Saws

 Monday, February 24, 2020

IMA Schelling Group has announced that they are producing refurbished and resell used IMA and Schelling machines at its rebuild center in Morrisville, NC. As  a provider of sales and after-sales, they extends their support to the woodworking industry with these machines that may be utilized to manufacture products for the woodworking, metalworking and plastics industries,

“Our thorough rebuild process brings IMA and Schelling machines to like-new condition,” explained Peter Tuenker, Managing Director, IMA Schelling Group. “We are actively seeking panel saws and edgebanders to purchase for trade-in value toward a new machine, then we’ll revamp and resell the machines on our website.”

REFURBISHED SCHELLING PANEL SAW

2004 FMH 330 auto load Machine # 203.019:

• Auto load machine
• Maximum cutting length: 3230 mm
• Maximum cutting width: 3100mm
• Book height 4”
• Powered infeed conveyor: 1600 mm wide, 3100 mm long
• Call for pricing

Scope of Refurbishment:

• Replace all cables in wire harness of saw carriage and feeder
• Replace bearings of saw carriage and realign
• Replace bearings of feeder and realign
• Check and replace rubber of pressure beam and table lips if required
• Detailed cleaning of machine
• Repaint scratched areas
• Replace or repair any damaged items
• New 17 inch flat screen display
• New machine PC with Windows XP

REFURBISHED SCHELLING PANEL SAW

2000 FMH 430 manual load Machine # 202.460:

• Front load machine
• Maximum cutting length: 4230 mm
• Maximum cutting width: 4100mm
• Book height 3”
• Call for pricing

Scope of Refurbishment:

• Replace all cables in wire harness of saw carriage and feeder
• Replace bearings of saw carriage and realign
• Replace bearings of feeder and realign
• Check and replace rubber of pressure beam and table lips if required
• Detailed cleaning of machine
• Repaint scratched areas
• Replace or repair any damaged items
• New 17 inch flat screen display
• New machine PC with Windows XP

IMA Schelling Group’s dedicated rebuild center in Morrisville, NC, features skilled technicians that clean, rebuild, repaint and install software upgrades of pre-owned IMA or Schelling machines. During the rebuild process, each machine is cleaned, evaluated and every component tested. Parts are repaired as needed using genuine parts prior to reassembly, then the equipment is calibrated to original factory specifications to restore the machine’s original appearance and performance capability. All machines undergo comprehensive testing and assessment to assure that they have been restored to full functionality.

Tags: edgebanders, IMA Schelling, IMA Schelling Group, managing director, panel saws, Peter Tuenker, woodworking, woodworking industry