Monday, June 26, 2023
SNX introduces the new generation of nVision contour edgebanders. The SNX nVision G1 & G2 Contour Bander Machines come with various new features that are helpful solutions for the woodworking industry. The quick-change glue pot system, enhanced PC controller and trimmer chip vortex extraction efficiency make these two machines highly efficient and productive.
SNX nVision G1-
The SNX nVision G1 is a semiautomatic contour (curved) edgebander. This machine has been designed for the tightest butt joints and radiuses. This can edgeband curved surfaces up to 5′ x 10′ weighing up to 230 lbs. One can also use this to easily band .5″ – 2.25″ thick boards with .5mm – 3mm tape. It is not only very easy to use and operate but it also has a simple setup system.
SNX nVision G2-
The SNX nVision G2 is a curved edgebander can handle shaped part banding throughput to the next level. It has dual arm contour bander with three-stations. It also displays an extended base frame that eases banding and trimming at the same time. A foot pedal activated mid-point transfer station accepts the finished banded part, raises it from the vacuum pod and then lowers the part onto the trimming pod arm at the press of a foot pedal.
These two improvised edgebanding machines come with some special features such as-
• Faster processor and a more accurate encoder for more consistent tight butt joints
• 15” touchscreen monitor
• Training & Maintenance videos on PC
• Connect to the internet for service and updates
• More user-friendly interface
• Bar code capable (optional)
These two own banding stations. The trimming station comes with one set of cutting tool, two articulated vacuum arms, edgeband coil stand, and two standard-size vacuum pod for banding station articulated arm.
Tags: SNX Technologies, wood, wood and panel, woodworking, woodworking and manufacturing, woodworking industry, woodworking USA
